Fridge Child Lock (Safety)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you happen to have the same fridge as me, there are two screws put into the door surface right between the upper…
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 25
- Wydruki
- 1
- Wyświetlenia
- 898
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
If you happen to have the same fridge as me, there are two screws put into the door surface right between the upper freezer and lower fridge. I believe they are so you can swap the direction the fridge opens from side to side. They are mounted just right to add a small flat panel with some cutouts to the side that allow you to insert a rope, with a knot on the end, to "lock" the fridge from inquisitive toddlers.
In the photos, you can see some scrap material used as a rope however I later picked up some ~3mm paracord and found this would work well too (and it looks a lot better too although once you start safety proofing for kids, looks are pretty low down on the list after a year or two).
(and yes, I see a bit of cleaning on the fridge door is needed!)
Print Settings
Printer Brand:
Creality
Printer:
CR-10S
Supports:
No
Resolution:
0.2mm
Infill:
20%
Filament:
eSun PLA+
White
Notes:
Print flat on the bed without supports.
Category: Household