1 / 1
SpeedSloth Rear Plate for P Lok Clips — zdjęcie 1

SpeedSloth Rear Plate for P Lok Clips

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement back for easier, more stable mounting

Ocena
0 / 5
Polubienia
10
Pobrania
14
Wydruki
0
Wyświetlenia
132
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Use 4x1: https://www.printables.com/model/1515564-p-lok-printable-molle-clip-v1

Why?

I found D2 maker's tab backplate to be much better than the original speedsloth, but overtime as the clips wore down and tolerances got looser, I had occasions where they would get loose, or sometimes fall off. Once I printed Dipshit Designs' P-Lok clip for a fidlock plate, I found it to be very stable and wanted to convert my speedsloths into these clips. I find these to be much more stable.

Print Settings

Around 3-4 walls 20% gyroid is fine - these don't need to be very strong unless you really beat on them

Supports on screw holes only - The indent where the mag feed lips go should not need support

Assembly

Assembly is the exact same except the knot at the end

Instead of threading the elastic through the little holes on the backplate like the original, after going through the detent clip for the last time, tie it off there

Pic for reference:

Tagi