CFS - Folding Silica holder (extra capacity)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
CFS - Folding Silica holder with extra capacity and easy to mount
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 128
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is my try of a Silica holder for Creality K2 Plus CFS.
I tried and 3d printed some other models but i was not happy by the capacity or the print time and structure. So i give it a shot.
I knew i wanted to try a folding structure to improve on the small slots. I added some magnets and a lid.
To print this: use 0,4 nuzzle and 0,24mm layer height.
You will need to print:
1x CFS - Folding Silica holder (Magnets)
1x CFS - Folding Silica holder (Magnets) MIRRORED (you can do it directly in OrcaSlicer)
2x CFS - Folding Silica holder (Magnets) Top
2x CFS - Folding Silica holder (Magnets) Base
you will need 16x M1,7x10 plastic screws (or whatever you can screw in)
10x 6x2mm neodymium magnets
Try and use double tape to mount the Base with the three magnets as close to the middle as possible otherwise the lid will hit the holder. I am recommending to measure the center of the CFS and then gluing the base with the magnets.
I don't know the volume but if i would guess it will be 350...400gr
Good luck printing it.