Hoist HF-5165 Weight Bench Angle Shims
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Angle Shims for the Hoist HF-5165 weight bench allows setting angles between the angle stops
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 17
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Indoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
Angle Shims for the Hoist HF-5165 weight bench allows setting angles between the stock angle stops; like 40 degrees. There's a +5 degree and +10 degrees block.
There are two 15 x 2mm magnet pockets on the back to help hold it in place when it's not in use. These are optional but it does help keep the blocks from fly out when I'm enthusiastically rolling my bench around the gym. Just search Amazon or whatever site you like for 15 x 2mm magnets
Prints without supports and it's best to print it on it's side for anisotropic reasons.
The settings probably don't make that much difference but I printed it in PLA, 5 perimeters, 15% gyroid infill and they're plenty strong enough.
Happy lifting!