Snapmaker Artisan Spool relocate with rollers inside Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a set of parts I designed to relocate the stock spool holders for the Snapmaker Artisan
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 281
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a set of parts I designed to relocate the stock spool holders for the Snapmaker Artisan, They allow the spools to be located inside the enclosure without the need for PTFE tubes which can cause drag on some filaments. The bar and rollers also allow you to use an external mount/dry box and still not use PTFE to the hot end. To use this function insert PTFE connectors to the back side of the bar, there are 4 holes so you can feed from either side, then no PTFE from the bar to the hot end. I do like about 3 inches of PTFE in the hot end to smooth the transition from horizontal to vertical. I like this method because as the part gets higher the filament gets shorter without getting tangled. The spool mounting brackets attach to the back of the pillars and angle out allowing a more direct path to where the hot end spends most of its time, towards the center of the bed.
You will need,
One piece of 4mm (I used 10/32) all-thread or similar 43cm - 46cm long with locking nuts to mount the rollers on.
8 @ 5mm x 12mm
4 @ 5mm x 16mm with nuts
2 @ 5mm x 25mm with nuts