Bach's Key Hanger in Alto Clef

This key hanger was made based on one of my wife's favorite pieces, Bach's cello suite no. 1 prelude. She plays viola so I made it in alto clef. The key hangers come off the bars on the notes to try and make them blend in a bit more. You could probably fit more keys on here, but I minimized the number of hangers to keep it looking a little cleaner looking.

I printed this with a 0.4mm nozzle and 0.2mm layer height on a Bambu X1C with both the base and notes printed together as different colors, though I suppose you could print them separate and glue them together most likely. I ironed the surface on the base and caps only since the black had smaller pieces and generally hides the as-printed surface better. I used Polyterra filament for the black and white (except the caps which I did in Polylite Pro just because I ran out of the Polyterra white.

Note: I printed an older version before I added the small cutout below the screw holes. This was added so you can take off the caps more easily if needed. The caps themselves are slightly tapered to help with fitting into the holes.

Update: I added a version with "No holes" so that the white base can be printed without the holes intended for screw mounting. I've also added the .3mf file from my project setup.