Model 20 3D Set Mogster Battery Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I did this battery holder to install the lipo battery under the rear box, the chassis has a lot of space there.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 187
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
I did this battery holder to install the lipo battery under the rear box, the chassis has a lot of space there.
It will work great if you are not using the box lifter. I did with PLA 0.20mm layer, 4 perimeter and supports.
You will need to use 4 3x10mm socket head screws, install the 2 screws going to the front of the car firts, then install the battery holder and the head of the screws will enter into the chasis holes(front side), them after that you will be able to add the rear screws across the rear holes of the chassis. It will fit great. I make holes to a battery strap too. As you can see the head of the screws fit great into the holes of the chassis so they will hold the box in place dont even need to to tight them. I notice a better weight distribution with the truck like this and better balance too. I guess it will work only for the 4x4 model but maybe can be modified for the 6x6. For the battery cable a did and extension and thats all.
Try out.
Regards
Enrico Vargas