Small thumbwheel for bed leveling
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small 18mm thumbwheels from manually adjusting beds on assorted derivative i3 kit printers. Replaces smaller metal…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 231
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Small 18mm thumbwheels from manually adjusting beds on assorted derivative i3 kit printers. Replaces smaller metal thumbscrew nuts and wing nuts but should not bump into anything.
An M3 screw has a 0.5mm thread pitch when means a full turned of a bed leveling nut moved the bed 0.5mm. Two turns would be a full millimeter. The thumbwheel I designed has 10 points on it so every point is 0.05mm height change. Two points would move that corner of the bed up or down 0.1 mm.
I created another thumbwheel design that is too big for some of my newer i3 kits.
This thumbwheel works well with Tronxy X3, Zonestar P802M, Anet A8, and a few other i3 kits.
If you find this useful, please encourage me with a tip.
UPDATE: added a new version with the numbers in reverse per maker's correct logic: small_thumbwheel_rev2.stl <-- use this one from now one.
Print Settings
Printer:
Tronxy X3
Supports:
No
Resolution:
0.12mm - 0.16mm
Infill:
20%
Notes:
Has a built in support ring that you should be able to push out with a 2.5mm hex wrench. A M3 nut should press fit into it.
3 shells.
Post-Printing
Use a 2.5mm hex wrench to pop out the support ring.
Press in an M3 nut.
How I Designed This
I used my drug of choice, Onshape.
Started the design on my iPad, then refined in on my iMac.
Category: 3D Printer Parts