Sliding board for Thermomix TM6 (and possibly TM5)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A board that lets you move your Thermomix around the worktop, without lifting it
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 387
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a sliding board for the Thermomix TM6. May work with the TM5 - I don't have one so couldn't verify.
Requires a 300x300 bed!
Print 1 board, 3 feet, 4 rollers and 2 connectors.
PETG works for the board. PLA not recommended, may sag with use. Print top surface down. This is a large, flat print: to avoid post-print warping, wait for the bed to cool down to ambient temperature before removing!
TPU for all other parts. I used 95A (don't have any other). The feet and the rollers have special features to add friction. I think the grip of the feet could be even stronger with a slightly softer material.
The 3mf files were generated in Orca for the stock Qidi Plus4 profile. If you prefer your own settings, pay attention to "Slice gap closing radius" deliberately set to 0.024 for the board - this enforces longer wall lines along the roller axles and makes them (in theory) harder to accidentally break off.
The feet are a tight fit and may require a thin, flat screwdriver for the protrusions to fully come out of the mounting holes.
Be especially careful when mounting the connectors between the rollers - bend the connector, not the axles!
