Grip6 Belt Hanger

I discovered that Grip6 created a new hanger for sale on their site and found another published 3D model; however, I did not like some aspects of them. This is my first time using Fusion to model something this complex.

Total capacity is 5 buckles and 6 belts, designed for the 1.5" width belts.

Some notes:

• The original design has only one hanger; this design has two.

• The tabs can be printed separate or with supports. The slots are 0.2mm larger in each direction. I used super glue on the bottom joint of each tab.

• I've included versions with and without screw holes.

• I changed the angle of the side slots to be perpendicular to the side; I did not like them at an angle.

• I deepened the side slots so that the belts slide in farther. The original design allowed the belts to fall out too often.

• The side slots can handle the newer belts and also the older belts. The older belts have tabs that were not machine molded but rather hand melted and can be quite wide.

• The back has a recess to allow flush wall mount when using Command strips.

• I moved the hangers lower so that the buckles would hang more vertical, as the original design paused the belt to push the bottom of the buckle out.