Dental Burr Holder V1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Burr stand for 36 burrs.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 71
- Wydruki
- 0
- Wyświetlenia
- 259
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Burr stand for 2.35mm shank burrs, mostly used by dental technicians.
Simple one piece print, make sure the bottom is placed fully on the print plate, I used PLA, you can use whatever you prefer, also 15% infill, brim, supports everywhere. I chose 15% infill because the part is big and to me it doesn't really matter, you need brim around the perimeter to keep the part in place and it helps to avoid warping, I also check supports everywhere because why not lol.
Burr holes are 2.75mm so you can easily insert or remove burrs.
On the bottom there are 20 places for silicone legs (cabinet door stops), hole covers are very easy to remove with any tool that fits, holes are 10.3mm, so you need 10.0mm rubber legs.
I also made Burr Holder V2, it's the same burr stand, only with magnets and extra parts.