1 / 3
75mm Open Prop Frame like Firefly Nano Baby for Moblite7 WS or HDZero Parts — zdjęcie 1
1 / 3

75mm Open Prop Frame like Firefly Nano Baby for Moblite7 WS or HDZero Parts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Open-prop frame for Moblite7 WS or HDZero parts that is similar to the Firefly Nano Baby frame | Easy Print and Tough

Ocena
0 / 5
Polubienia
4
Pobrania
22
Wydruki
0
Wyświetlenia
129
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

I wanted a frame to replace the stock whoop frame for my Moblite7 WS frame, when I eventually broke it. I wanted it to be quick to print without supports and have no issues due to layer adhesion on small sections like most printed whoop frames do.   

I print the frame in PETG with 0.2mm layer height, 4 perimeters as I think the uniform direction and continuous layup of material around the holes matters for strength, 100% infill.  I've crashed hard tons and the frame is like new.  I think it's nearly indestructible from most normal crashes.

To attach a battery, you can either use a small rubber band, or a TPU battery mount (stl for 650mah 1s included), or both.

I've also included a minimal prop guard that does a pretty good job protecting props indoors without being very heavy or hard to print.  PETG preferable, PLA will work too but be less durable.

TPU 650mah 1s battery mount I print at 25% infill, could use less, as the "box" offset  from the bottom plate does not need to be very solid.

You will need M2x12 screws (can get away with M2x10 without the prop guard) as the original moblite7 screws to mount the FX & VTX cause durability problems on 3d printed frames, being so small and so easy to strip the plastic, so I made the holes all for M2 instead.

Tagi