1 / 5
12 Gauge Shotgun Shotshell Holder (Matchsaver) - M-Lok Compatible — zdjęcie 1
1 / 5

12 Gauge Shotgun Shotshell Holder (Matchsaver) - M-Lok Compatible

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Single 12 gauge shotshell holder with M-Lok compatible mount.

Ocena
5 / 5
Polubienia
258
Pobrania
2007
Wydruki
11
Wyświetlenia
12 613
Oceny
11

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Simple, single 12 gague shotshell holder to give sporting shooters that one last round to complete a stage (when you miss that last critical shot - we've all done it!).

This is a remix based on glompos21 design on Thingiverse.

I've modified the design to be M-Lok compatible, which will fit Magpul equipment and other manufacturers that use the M-Lok mounting system.

It will fit all 12 gauge shotshells, from 1 ¾" shorty shells right up to 3 ½" super magnum.

Print settings:
PETG recommended for heat and UV resistance
0.15mm layer height
40% gyroid infill minimum (but I recommend 100% rectilinear infill)
3 perimeters if you're using less than 100% infill
No supports

Two t-nuts and screws are required to mount the matchsaver. I recommend all-metal T-nuts, but 3D-printed models such as this design may work. Make sure you check the clearances on the back side of where you plan to mount the matchsaver as the 3D printed T-nuts have a much deeper profile than all-metal ones, which are designed to be low profile.

Tagi