1 / 2
CREALITY K1 | K1C | K1SE - LID RISER V1 chain pocket remix — zdjęcie 1
1 / 2

CREALITY K1 | K1C | K1SE - LID RISER V1 chain pocket remix

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Reboot from LEOTE's original design. For better use with CFS upgrade

Ocena
0 / 5
Polubienia
8
Pobrania
71
Wydruki
1
Wyświetlenia
546
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

I have been running the V1 lid riser from @LEO_app for a while now and I'm happy with it for the most part. It was one of my first prints after getting the printer.

The chain used to smack the side wall which was tolerable but after upgrading to CFS the PTFE tube comes out of the chain and I decided to use clips on top. These were breaking due to the side panel pocket not being tall enough. Re-printing a whole new riser setup didn't seem appealing so I just maxed out the side pocket as much as I could and I haven't snapped a clip yet.

 

Straight swap part. Print the same as the original setup - Standing up with supports (I use tree hybrid, build plate only)