Lid for Fellow Stagg Electric Kettle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement lid for the Stagg series of kettles from enthusiast coffee accessory brand Fellow
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 182
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
A new lid I modeled for my Fellow Stagg electric kettle. While I have only tested it with my Fellow Stagg, This should work with all the derivative models in the Stagg product line.
I think it goes without saying, but you should be using a high temp filament for this. PETG at the very least, though HT-PLA or ABS/ASA are recommended. I used Proto-Pasta HTPLA-CF, and annealed the part for higher temperature resistance. As long as the filament you use can comfortably handle 100c/212f degrees, then you should be good.
Assembly
1x M3x12 Screw
1x M3 Nut
Once both parts are printed and annealed if using HT-PLA, place the M3 nut into the hexagonal indentation on the underside of the lid. The tolerance should be fairly tight, so it may be difficult to insert the nut initially.
Next, insert the M3x12 screw into the top of the lid handle (Hint, the top side is the large of the two ends), Once it is inserted, place the handle onto the top of the lid, and use the nut to secure the handle to the lid.