Leatherman ARC mod - toothpick and pin holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
With this mod you can add the capability of toothpick and pin to your ARC.
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 77
- Wydruki
- 1
- Wyświetlenia
- 617
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Leatherman ARC mod that adds the capability to carry original Victorinox toothpick (or tweezers) and pin. You can use the original torx screws that came with your ARC to secure the mod.
The pin and toothpick can be bought separately on Victorinox website, you don't need to have a Victorinox knife.
I recommend using PLA, 0,25 mm nozzle, 0,07 mm layer height, 100% infill and large brim. See the photos for recommended print orientation. Use really slooow printing speed.
The print uses less than 1 gram of filament!
When fresh from the printer, the tolerances for the toothpick and pin are really tight. Just use the toothpick and pin and go back and forth a few times to adjust the slots.
Sometimes the slot for the pin is really tight. Try to use some hard surface to push the pin inside and then some pliers (for example those on your ARC :-)) to get the pin out. When you do this a few times, the slot will adjust just fine. Just be careful not to bend the pin.