Grippy Stick Ends For FPV Controllers - Radiomaster/Jumper/Taranis - No Inserts!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Grippy Stick Ends For FPV Controllers - M4 - No Inserts!
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 237
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
These stick ends provide a lot more grip and comfort than standard ones, they are slightly higher, thicker, and have lots of small spikes which provide great grip, but don't hurt the finger. Works perfectly with hybrid grip, but will also work with thumbing/pinching. They're perfect for sweaty hands, because they don't slip like the metal ones, and you can print them as a permanent solution, or to try out before purchasing some higher-end ones.
They should fit any radio with standard M4 mounting, like Radiomaster Boxer/TX16/TX15, Jumper T14/T15, Taranis, and many others.
Print settings:
This version is slightly re-worked for FDM printing, but you still should use 0.2mm nozzle and low layer height
Print with PLA/TPU/PETG/ABS/Nylon - anything
Add a brim for better stability
No supports
If your printer isn't very precise, or the material has warping, add some X-Y hole compensation, but don't add too much, so it isn't loose and screws on tightly