Custom Cinnamoroll Car Emblem V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Version 2 of a custom Cinnamoroll logo designed to replace stock brand emblem on a Toyota Corolla
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 109
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A custom Cinnamoroll logo designed to replace stock brand emblem - the posted model is made to replace the 100mm x 70mm rear Toyota badge on a Corolla.
To give enough space for the “floating ears” I added a hexagon lip on the rear of the emblem and used that hexagon as a guide for placing adhesive tape on the outer or inner lining of the hexagon. I used an exterior grade automotive adhesive tape that was just the right thickness for the hexagon.
Step by step guide:
(Step 6 and 7 can be skipped if your patience allows OVERLY THOROUGH sanding haha)
Remove the original emblem using a heat gun and dental floss.
Clean the area with glass cleaner, acetone, and IPA/EtOH. Use acetone only on sticky residue—try best to avoid painted surfaces to minimize paint damage.
Print model with PETG.
Do basic post processing as you usually would do and sand the printed model to prepare surface.
Spray SEM 39863 Plastic Adhesion Promoter on all sides.
Use 3M 05887 EZ Sand Flexible Parts Repair to fill in any big imperfections or layer lines, sand and lightly spray Plastic Adhesion Promoter again after fully curing.
Use SEM 39133 Flexible Primer Surfacer to even out the surface.
Color coat: I used black base coat with Delta ColorShift and 2K top coat purchased from Didspade.
Attach with 3M automotive exterior adhesive tape. May use a heat gun to increase adhesion.