Paw Nudge Button Protector for BLUEAIR Blue Pure 211+ Large room air purifier (Sold through Walmart)

I designed this to solve a real-world problem: my cats like to jump up and sit on the air purifier, and when they do, their little tushies press the button, usually turning it on to "full blast" from "as needed" mode.

Prints upside down.  Use the pegs to align to holes in the purifier to keep the protector from sliding/moving.

I recommend printing in PLA+.

R4 is the strongest version.  Prints with minimal support.  Requires about 1h 15m hour to print.  It's larger and tougher.  Recommended.  It does cover the most exhaust holes.

Features of R1:

• Hooks into top

• Allows human access to button

• Allows you to see the 3 lights

Important note: you need to scale this by Z only at least 400%

Features of R2:

• Does not require support

• Beefed up hook-in connectors

Print R2 for easiest no-support print.  Print original if you want something sleeker.  Included the R1 donut model so you can mess around with it in TinkerCAD.

Features of R3:

R3 is the a nice version, can print with only a little support but it still presses the button when you press on it, so not ideal. ... the previous two were too thin and caused issues.  R3 is partially based on another Printables model, someone already designed: https://www.printables.com/model/624447-blue-air-211-auto-button-cover but I have to be honest, if you press hard enough on the rim it does press the button :(

Made for: https://www.walmart.com/ip/Blueair-Air-Purifier-Blue-211-up-to-2-592-sq-ft/391960279