Slide Action for Cricket Pro Blaster
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a slide action to replace the lever action of the original. Makes this a nice little single shot blaster.
- Ocena
- 4,667 / 5
- Polubienia
- 15
- Pobrania
- 48
- Wydruki
- 1
- Wyświetlenia
- 254
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
This Slide action makes cocking the Cricket Pro much easier. I could not get the lever action to work at all. It also makes it easier to load a dart through the breach.
The rear sight tabs must be cut off and smoothed for the action to work. I don't use the sights anyway. Just point and shoot.
Maybe Goombasinastack could create a receiver without the rear sights? If I'm honest it was just easier to cut them off.
You can also substitute a trigger pin for the lever pin that holds on the grip (see red arrow in photo).
Print the slide standing on its end as shown in the thumbnail.
For all other parts see Goombasinastack's original model. https://www.printables.com/model/1043838-cricket-pro-high-power-low-hardware-stringer-blast