1 / 5
east3D gecko coreXY Z-wheel-carriage — zdjęcie 1
1 / 5

east3D gecko coreXY Z-wheel-carriage

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I created these to fix an issue that i had due to poor handling by the courier . Parts Needed. 4x 3d printed z wheel…

Ocena
0 / 5
Polubienia
1
Pobrania
12
Wydruki
0
Wyświetlenia
380
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I created these to fix an issue that i had due to poor handling by the courier .

Parts Needed.

4x 3d printed z wheel carriage

4x http://openbuildspartstore.com/delrin-mini-v-wheel-kit/

8x http://openbuildspartstore.com/mini-v-wheel-precision-shim/

4x 6mm http://openbuildspartstore.com/eccentric-spacer/

12x http://openbuildspartstore.com/nylon-insert-hex-locknut-m5/

12x 30mm http://openbuildspartstore.com/low-profile-screws-m5/

8x (M5 washer works also) http://openbuildspartstore.com/precision-shim-10x5x1mm/

4x m6 washers like these. https://www.amazon.com/Steel-Washer-Plated-Finish-Metric/dp/B009OK4VLQ

assembly:

take off the wheels from the cart.

and remove it from the z stage.

insert one 6mm eccentric spacer into each carriage .

screw the new carriages to the carts with the m5x30mm screws. nice and tight.

(wheels are now held inplace with nuts.)

wheel instalment.

copper spacer first then wheel last precision shim. (or a m5 washer works)

last the nut and hold the bolt with the allen key so it does not want to loosen.

put the carraiges back on the z stage.(do not tighten the bolts till the end)

now the mini wheels .

put the M6 washer on the m5x30mm bolt put it in thru the hole a step at a time now put a mini-v wheel precision shim then the wheel then another mini-v wheel precision shim then the nut. tighten up the eccentric spacers to hold the wheels enough . not to tight( you should be able to spin the wheels with slight resistance ) finaly tighten the carriages to the z stage.

(i do advise to relevel and retighten the z belts at this time.)

Print Settings

Printer:

east3D gecko coreXY

Rafts:

No

Supports:

Yes

Resolution:

0.20

Infill:

100%


Notes:

support from build plate only.

How I Designed This ===================

Category: 3D Printer Parts

Tagi