2x92mm Fan Panel Mod for Jonsbo NV10
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A custom panel made for the Jonsbo NV10's GPU side panel, uses 2x92mm slim fans to help with ventilation.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 240
- Wydruki
- 0
- Wyświetlenia
- 1766
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Open Community License v1
The Jonsbo NV10 isn’t well known for good airflow along the GPU side panel, so I designed a custom panel to replace it with something that provides significantly better airflow. It’s designed to work with two 92mm slim fans and a deshrouded RTX 4060/5060 LP GPU, and doesn't even exceeding 70°C with two Noctua NF-A9x14 HS-PWM fans running at only 80% RPM and a slight undervolt (2730 MHz at 950 mV). The fit is a bit snug, so don’t be afraid to handle it.
Dimensions: 202 mm × 202 mm × 2 mm
Tolerance: ± 1 mm (differs from print to print)
Notes: This mod isn’t compatible with the ASUS RTX 3050 LP BRK OC Edition (and similar models) because the DVI-D port is tall enough to conflict with the leftmost 92 mm slim fan leaving a noticable bulge on the panel. It’s also easier to connect the two case fans directly to your motherboard and to use the "Fan Control" program to sync the fans’ RPM to the GPU. If that doesn’t work, you can use a 2×4-pin fan adapter to connect the two fans to your GPU’s fan connector and use MSI Afterburner to control the fan settings from there.
This was printed using off-the-shelf PLA and has printed successfully on the Creality K1 and Ender 3 V2 I have. The PLA panel didn’t warp or sag when I forced the GPU to 80°C even after a 1-hour stress test.
This is open for everyone to use/remix/share. If there are any issues with your final print of the panel, you have both the STL and SolidWorks SLDPRT files to make any changes. You just can’t sell this specific version without my permission >:3