[Testing] openGrid tiles with built-in peelable hole covers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
openGrid tiles with built-in peelable hole covers
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 134
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These tiles print with built-in hole covers, which you can peel off (see GIF) for the holes you will actually use. You can have the utility of tiles with threaded holes with the aesthetics of plain tiles.
Currently in testing. I will upload all sizes once testing is finished.
Testers needed (10-min print)
Bridging is a bit more challenging than usual, because it's also 0.2mm off the layer below to allow removal. So I'd like to test the following variants (total 10-min print time):
2-layer cover
2-layer cover with modifier
3-layer cover
3-layer cover with modifier
Modifier changes the wall count of the cover to 1, allowing bridge endpoints to be supported from below.
For Bambu printers, use the Bambu 3MF. For others, use the Orca 3MF (and switch to your own printer profile). Print all layers at 0.2mm.
Test objects have vertical lines on the side to indicate which is which. Please post your results and tell me which one comes out looking the best.