1 / 8
Kobra 3 Max ACE Tube Guide - 8 Color — zdjęcie 1
1 / 8

Kobra 3 Max ACE Tube Guide - 8 Color

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A guide for the PTFE tubes from the ACE unit(s) to the print head. Supports up to 8 colors.

Ocena
0 / 5
Polubienia
12
Pobrania
133
Wydruki
0
Wyświetlenia
406
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Anycubic Kobra 3 Max Tube Guide - 8 Color

These printable tube guides will allow you to keep the PTFE tubes from your ACE or ACE Pro organized and supported to reduce sag. The power cable is intended to run down the middle and can move freely, while the tubes are held securely in place. I have opted to include the STEP file for best quality print results and easy remixes.

Important notes regarding how to use these:

  • Do not over-tighten the zip ties or you will put pressure on the filament inside the tube. Only tighten them enough to hold the guide in position so it does not slide around.

  • You don't need to use as many as I did, I just had a bunch of them and decided to put them on now so I can reposition some later. 3 or 4 is probably plenty.

  • If you route the cable through the middle, keep in mind you won't be able to slide the guides past the point on the left where the cable clips onto the gantry. You can install more guides behind that by simply pressing the tubes into the holders.

  • If you're worried about scuffing the outside of the tubes, try printing these in TPU 95A.

Recommended Print Settings:

  • 0.4mm nozzle (0.6 will also work)

  • 2-4 walls

  • Infill will not make any difference.

  • for best looking results, enable single perimeter top layers

  • Supports disabled

Tagi