PanaVise Model 301/300 F Clamp Baseplate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Raised PanaVise mount to allow for compact clamping to a surface
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 56
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This design adds a bottom plate and then a 1 inch air gap up to the PanaVise 301 base's bottom, aka the PanaVise Model 300 Standard Base. This gap allows for clamps to be positioned under the PanaVise rather than beside it. This means the PanaVise can be positioned very close to the edge of a work surface while still being very secure.
This is similar to PanaVise's own Model 311 Bench Clamp Base Mount. The details for this mount plus the Model 300 Standard Base and Model 303 Standard Head (300+303 makes the 301 Standard PanaVise) can all be found in the attached PDF from PanaVise.
I printed this using 20% Adaptive Cubic infill, 3 wall loops, 5 layer top and bottom thickness, 0.2mm layer height in PLA. I haven't had issues with the model compressing or cracking, but if it were to happen I would increase all the settings mentioned above to bulk up the print.
I use 1-1/4 inch countersunk #10 screws to secure the Panavise 301 to this base. https://www.amazon.com/dp/B08FBVD9SX
I use F clamps (600lb rated, 3 inch throat) to secure the printed base to the work surface. https://www.amazon.com/dp/B0CPXW87HL
The Panavise mounting pattern says it's a 4-5/16 circle with 1/4 inch countersunk mounting holes. https://mm.digikey.com/Volume0/opasdata/d220001/medias/docus/6168/309.pdf