PB Swiss Magnetic Pegboard Screwdriver and Pick Holders - phillips & flathead & picks
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetic pegboard holder for PB Swiss phillips & flathead screwdrivers & picks
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 79
- Wydruki
- 1
- Wyświetlenia
- 460
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
These are redesigned versions of my old holders. I wanted something that was more uniform and looked better being printed. And I wanted them to be easily removed and put back. My old design required me to lift them up before pulling them out
Use 3x6mm magnets. The hexagons holes allow you to get them out easier if absolutely needed. But you do need to hammer/press them in. No glue needed.
Printing
These have been designed around easy printing without any supports.
About the cleats
This attaches to the pegboard using cleats so it can securely attach to the pegboard. Why? Well when I would remove some of my tools, the holder would come out with it. The video explains a lot of it.
I included 2 different cleats (depending on how tight they end up printing) and the step file for them so you can modify them as needed. They print just fine without supports and I have been using PLA for it without issue (quick to print more if you break them). I also found that sometimes I needed to deburr them to get them to slide easily. But it's also kinda nice if they don't slide super easily if you are doing a semi-permeant. You can just lightly use a hammer to get them to slide all the way down.
If they break off, Ive just used a hammer and a small screwdriver to back them out of the groove
If you want to make you own thing using the cleats , I have a starter kit here: https://www.printables.com/model/1338463-pegboard-cleat-system