2024 Kia EV9 CCS Charge Port DC pin guide cap replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This guide cap snaps into a DC charging pin for the EV9 CCS connector. It replaces factory caps that may "unsnap".
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 202
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
The 2024 Kia EV9 has a snap-in plastic guide cap that fits on the end of each DC charger pin in the CCS charge port. Kia is not known to offer replacements for these when they "unsnap" and are lost at random DC chargers. This design is a recreation of the Kia part made with the help of AI.
Ideally this part would be printed in nylon or other higher-temperature tolerant filament that is strong and elastic, a good electrical insulator, and will not absorb water. This is a snap-in part and the hold strength is based on the plastic retaining it's form for spring force.
Since nylon is challenging for many printers I tested with PETG. The charge connector is not supposed to get hot when charging - and my PETG test has worked out well. But corrosion or bad connectors could create temperatures higher than plastics can withstand. This could soften the plastic and allow the "snap-hold" part to release and fall out, or worse melt and gum up a charger connector. Certainly PLA would not be a good idea.
Recommended print settings
Layer height: 0.20 mm. It is a small part requiring good strength so I actually printed the ones imaged here at 0.15 mm.
Perimeters: 4
Infill: 100%
Orientation: axis vertical
Nozzle: 0.4 mm
No supports
ChatGPT helped me develop this 3D model. I measured the cap my car still had and reproduced it. Other cars may be different.
In addition to the stl file, I have attached the OpenSCAD design file. This will make it easier to modify the part should it need adjusting. OpenSCAD is a free 3D CAD Modeller software that offers a programmatic approach to design. Assuming the overall shape is OK, the scad file allows easy dimensional adjustments.
This is the part I have reproduced:


The new design looks like this:




Visual and caliper comparisons match to the best of my ability.

This is how you know you need this part. The black plastic guide cap is missing from the right-hand DC charging pin. Note that these pins are hollow and have a detent inside for a clip to catch:

The parts fit great when installed. There is a solid click at full insertion and they hold well.
Clean out the interior of the pin-there is no tolerance for dirt or debris from the old part. If part of the old cap remains it must be carefully removed. The interior hole in the pin is just over 3.9mm deep.
Both caps have been replaced in this image.
