Spelder Vertical Storage Token Holders
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Keeps Spelder coins in place when the box is stored vertically. Simple insert that stops rattling.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 31
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution
Spelder is a great game, but when you store the box vertically the metal coins slide down and start rattling against the lid.
I did not want to replace the box or move everything into a smaller insert. I just wanted a simple fix that keeps the original box usable while solving the vertical storage problem.
These token holders slide over the coin stacks and keep them firmly in place so nothing moves when the box is stored upright.
They are designed to be printed in vase mode (spiralize outer contour). This makes them print extremely fast, strong enough for this use case, and keeps material usage very low.
Print settings:
• Enable Vase Mode / Spiralize Outer Contour
• 0.2 mm layer height
• No supports
• Any standard PLA works
Print a set, place them over the coins, close the box, and you are done.
Works great and keeps the box clean, quiet, and protected.
