Chompy, The Filament Shark
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Chompy, The Filament Shark cuts the ends of your filament leaving a nice 40º shark bite across the end of the filament.
- Ocena
- 5 / 5
- Polubienia
- 106
- Pobrania
- 176
- Wydruki
- 7
- Wyświetlenia
- 2611
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Chompy, The Filament Shark cuts the ends of your filament leaving a nice 40º shark bite across the end of the filament. Chompy doesn't leave filament ends everywhere, and has a big stomach for holding many filament ends.
When Chompy is full, just lift the (magnetically latched) fin to let it poop all the waste filament into the bin.
This is a relatively simple print. No support required.
You can see Chompy in action here: https://www.youtube.com/watch?v=lVJGpDeQzrk
You need:
2x 10mmØ x 3mm thick magnets
30mm m3 nut and bolt
12-16mm m3 nut
A spring, around 5 - 6.5mm Ø and 15-20mm long.
A 9mm box cutter blade - available from most hardware stores (https://www.amazon.com/Amazon-Basics-13-Point-Carbon-Blades/dp/B08D9Q796F)
A dab of superglue in case the blade is a bit thin and doesn't want to stay in place.