1 / 1
Gasket for Minelab SD series metal detector — zdjęcie 1

Gasket for Minelab SD series metal detector

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement gasket or case seal for a Minelab SD series metal detector.

Ocena
0 / 5
Polubienia
0
Pobrania
7
Wydruki
0
Wyświetlenia
45
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial

A replacement gasket for sealing the case of a MInelab SD series metal detector. 

I'm in the process of repairing my 40 year old SD2100 metal detector, and needed to replace the gaskets on the control box.

Installation: Remove the six case screws at each end of the detector control box. Gently lift the case ends from the case, they are connected with a lot of fragile wires. Clean up the remains, if any, of the old gasket. Fit your new gasket between the case and the foil shield. Refit the case ends, and do up the screws. 

Should fit later GP and GPX series detectors, as they use the same style case.

I used Elegoo TPU95, but any soft flexible material should work. The model is only one millimetre thick, so needs four or five layers if printed with a 0.4mm nozzle. It uses about two grams of filament and needs no support.  A quick print, even when using slow TPU printing speeds.

Tagi