V60 T6 2025 USB C Phone Interface
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adapter to enable hands- free connection of your phone via USB C to your Volvo. Designed against a 2025 V60 T6.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 90
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Public Domain
Introduction
The design has been modeled 'to work' inside my car. That is to say, I have no proof that the dimensions will work in other V60s. I could have definitely spent more time in improving the shape, but a balance was needed.
Attached is however the source FreeCad 1.0 file, so you can adapt it to your necessities.
For assembly, the following quantities have to be printed:
1 x Main body
2 x USB C connector adapter (without any rubber boot) half shells
2 x Pins
Assembly Instructions
Basic Assembly
The half shells will need to be fitted together with tape after assembling them over the USB C connector.
Note that in my case I removed the rubber boot and I doubt that any rubber boot will fit into this design.
Then, push the connector into the main body from below. After that, fit the pins such that they keep the adapter inside the main body in place.
I am using a double sided tape (nano) at the bottom, just in case.
Adjustment Phone and Case
The attached FreeCad file (.fcstd) contains a spreadsheet called 'params'. There is currently only one parameter, 'ubsc_delta', which allows to adjust the connector against the main body. 0.0 works for my iPhone 15 with the case I am using, but yours may require adjustment.
In that case it is only necessary to adjust the value (e.g. 1.0 means that the adapter sticks about 1 mm further out) and reprint two half shells. All the rest can be reused.
Comments very welcome!