Interface Panel for Modular Pedal Board Guitar Pedalboard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Add dedicated 1/4" in/out connections to your board!
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 337
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
FOR USE WITH THE MODULAR PEDAL BOARD!
Linked below!
Add dedicated 1/4" in/out connections to your board, if you have two sections or more you can add one for the front of your amp & another for your effects loop! This is great for putting OD pedals & tuners directly between the guitar & the amp's pre section!
The snap-in cover should sit flush with the underside of the Interface Panel. Inset it into the opening with the sloping edge at the front as shown below. If it does not fit then please double check fitment & adjust scaling or your print settings & check the state of tune of your printer!
It does fit correctly when your machine is printing accurately! DO NOT leave a bad review or low stars because you got a bad print! That's just NOT cool!
BOM
x2 1/4" mono jacks
x2 1/4" 90º mono jack plugs
x2 PG7 cable glands
x2 25-35cm instrument cable (30cm used here!)
PRINTING
Print parts as imported with NO supports.
ASSEMBLY
The 1/4" jacks DO fit into the print but you will need to angle them into the hole from the side & ease them in to fit. It's best to solder the jack onto your cable before you install them in the interface panel! Feed the other end of the cable into the part, add the nut for the PG7 cable gland, then exit the cable from the rear of the unit. Fit the PG7 cable glad & 1/4' mono 90º jack plugs. Once finished it should look the images below!
To assemble the finished pedal board you don't need to use any fittings or fasteners, for the interface panel, the completed pedal will hold the interface panel securely in place by itself. However you could add some super glue to the side tabs as you insert them into the large openings in the pearl board feet if you require more rigidity.
Slide both side tabs of the interface panel into the large rear openings of the pedal board feet. They'll only fit the correct way round. Then add the top platform parts & secure.
Connect pedals by passing the cables through the gap between the two top platforms.
If you wanted you probably could use x2 extra 1/4" jacks instead of the PG7 cable glands. You may need larger washers however.
IMPORTANT
This model is NOT licensed for commercial use! If you wish to sell prints of my model please contact me first!
COMPATIABLE MODELS
Original pedal board here:
However I'd recommend this remix instead!