Magnetic door stopper and holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetic door stopper and holder
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 77
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an articulated door stopper and holder using 10mm x 3mm round magnets, up to 7 pieces. A M5 50mm bolt is required to connect the 2 parts.
The magnets are embedded into the door siding part. To embed the magnets the print must be paused at 4.2mm (z) hight.
The total width/hight is 80mm, to have room for a door handle also.
In case of metal doors this will be sticking to the door side, in case of other door materials a large washer is needed on the door. These are available usually in magnet shops.
There are 3 mounting holes for wall mount (center or 2 sides) for up to 4mm screws.
For best results and having also some flexibility, cushioning effect, I recommend to print on out of TPU.
3 walls and 15% infill should be fine.