2011 Ford Ranger Evap Line Clip Replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
When replacing my fuel pump on my 2011 Ranger 4cyl, 2wd during the disassembly when I went to press on the evap line retaining clip to undo it it just crumbled into nothing. I figured "no big deal right, I am sure they sell replacement retention clips." But no, as it turns out ford only sells the entire line system part number 9G291 for 870 bucks. So I went inside and drew up this little number on Autodesk Inventor and 11 minutes, 2 grams of filament and a Mayhew branded Ziptie that hose ain't going nowhere. Print orientation as pictured above and printed with 4 walls, 100% infill
IMPORTANT NOTE: If you are going to print this, you must use a filament and zip tie that can handle potential fuel vapors/spills. I used 3DFuel PCTG but would highly recommend Nylon.