Typhoon - A Bullpup Flywheel Blaster
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Typhoon is a very compact, simple bullpup flywheeler designed for 200 FPS competitive play.
- Ocena
- 5 / 5
- Polubienia
- 34
- Pobrania
- 66
- Wydruki
- 1
- Wyświetlenia
- 825
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
Typhoon is designed to be a super short bullpup to minimize the total length of the blaster while still remaining shoulderable. It is designed around high concavity brushed flywheels, specifically the Fuijin and Manshee flywheels. For best results, I recommend using these flywheels with either Raijin or Quickdraw motors.
From my testing:
Fuijin and Raijin combo got around high 180 fps with the pcar
Manshee and Quickdraw combo got around mid 190 fps with the pcar (This is the setup I would most recommend)
Accuracy was similar with both setups; however, if you aren't going to use the included pcar Manshees had much better accuracy
Note: Banned blaster wheels and motors should work just fine; however, I haven't tested them personally
If you want lower fps, daybreak flywheels will fit in the flywheel core; however, the pcar might not work as well at the velocities produced by this setup. You can also try using a 2s lipo with the motors and wheels previously mentioned.
Quick Printing Notes:
This blaster requires two very long prints; the upper and lower sections of this blaster will only fit on a 256mm^2 build plate or larger. These parts will also most likely warp if printed without a brim.
Update 5/10/26:
added support for metal roboman cages