Xiaomi Smart Band 9 Active Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A stand to use along with the band charging cable.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 86
- Wydruki
- 1
- Wyświetlenia
- 235
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Share Alike
This model is inspired by this design for the Smart Band 8 Active, but since I couldn't get the charge connector for the Smart Band 9 Active to fit inside that design, I completely remade it.
Printing
The model can be printed without supports. Just put it on its side, as shown in one of the photographs and it should print fine. You might get some hanging filament from the top of the cable slot, but just remove it with a xacto knife and everything should work fine.
Assembly
Slide the charge connector from the back of its reserved hole.
Seat the cable along the stand arm, then along the base. Note that on the base you have 3 possible cable configurations depending on from where you want the cable to exit (left, right, back).
Slide the cover from the side below the charge connector, to close it and avoid it falling down.
Optionally, under the stand base, there's a hole for a 60 x 10 x 3 (mm) magnet or weight. In case you want to put it, just glue it inside its allocated hole.
FreeCAD files provided for easy remixing. Printables has a nasty feature renaming the extension lowercase, so you might need to rename the FreeCAD files to have extension .FCStd if using a case sensitive filesystem.