Qidi Plus4 Box Spoolholder Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Add bracket to hold Qidi Box hub as well as an external spoolholder
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 242
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix to allow the Qidi Plus4 box hub bracket to attach at the same time as the spool holder. As you can see from the images, it does not block access to the screws for removing the back panel.
This spool holder can use either metric or imperial hardware, depending on what is easier for you to obtain. See the following remix for the list of imperial hardware required and some additional instructions.
Print it in the orientation it imports and no supports are needed. I used PETG at 4 perimeters.
When installing, be sure to not overtighten the screws that thread into the back panel of the printer
If you need a longer arm than the one in the original design due to the size of your riser and desire to hold the spool in a higher position, please see the following remix
Update (2026/01/28): I thinned the part so that only 2.5mm of screw length is consumed rather than 3mm. The original brackets are 2.1-2.2mm thick. This will ensure the screws grip enough of the back panel