Star Wars Venisa Doza's X-Wing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Model of Venisa Doza's modified T65 X-Wing from Star Wars: Resistance with moving print-in-place wings
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 75
- Wydruki
- 0
- Wyświetlenia
- 314
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles & Machines
- Licencja
- Creative Commons — Attribution
This is a model of the X-Wing flown by Venisa Doza in Star Wars: Resistance. It has moving print-in-place wings.
This ship is a modified T65 X-Wing. The cannons were replaced with two new cannons for the upper wings and missiles for the lower wings. The engines were also replaced with bigger models. The upper wings have cut-outs and the cockpit window is rounder.
Dimensions
length | width | height | |
|---|---|---|---|
wings closed | 45.6mm | 42.2mm | 8.3mm |
wings open | 45.6mm | 39.4mm | 17.8mm |
The version with pin is compatible with a small pin and base (link).
Print Instructions
I highly recommend you print the engines separately. If you print them attached to the wings, the nozzles will almost certainly break off.
For separate engines and no pin, print:
venisa doza-no engine.stl
venisa doza-engine.stl
For separate engines and pin, print:
venisa doza-no engine pin.stl
venisa doza-engine.stl
(version shown in the photos)
For attached engines and no pin, print:
venisa doza-print.stl
For attached engines and pin, print:
venisa doza-pin.stl
Printed at 0.15mm layer height. Requires supports on buildplate.
The part doza-engine.stl was printed at reduced layer height and does not need supports.
If you want to support me, you can do so via this link: https://ko-fi.com/printingdaniel#