Briefcase Phone Case (iPhone SE)

I would recommend printing in PLA, but other non-flexible filaments should work as long as they're sufficiently dry. Print The lid with the grid pattern facing down. This to prevent warping. Print with supports on. The lid can be pressed in from either side. The latches can be pressed into the lid in the notches. I strongly recommend gluing them in, but it is not strictly necessary. ALL 3 BUTTONS ARE NOT THE SAME SIZE. Make sure you keep the 2 volume buttons and power buttons separate. Putting your phone into the case is a little bit difficult. Take the volume buttons and put them into their holes (lower 2 holes of the 3 on the left side). Press the left side of the phone against it, holding up the right side while putting in the power button (right side hole). Then tilt towards the right so the power button doesn't fall out, and press the phone in.