Dart Zone Volcanic Carbine Pump-Action Mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement for the top priming grip that allows for pump-action priming
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 22
- Wydruki
- 1
- Wyświetlenia
- 271
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This mod for the Dart Zone Volcanic replaces the top priming grip with an attachment that allows for pump-action priming using any forward grip that can be attached to standard picatinny rail. No additional hardware is needed, but the three screws that attach the top priming grip are used to attach this mod in the same places.
I recommend printing the two long parts with walls at least 2.5mm thick, automatic mouse-ear brim, and manual support for the two faces show with supports in the picture above; no other supports are needed.
When assembling, be very careful not to over-tighten the screw at the rear of the blaster that holds the two printed arms together as there is not a lot of thread engagement so it is easy to strip the hole. This screw does not need to be tight at all, just secure.
The angled grooves on the inside of the arms are to allow the attachment of other parts, none of which I have designed yet, but I'm including the STEP files so you can design your own. Enjoy!