Tobii Eye Tracker 5 adjustable mount for Samsung Odyssey G7 G75F 40 inch

I've previously made a fixed mount for the Tobii Eye Tracker 5 for the Samsung Odyssey G7 G75F 40 inch monitor with 10, 12.5 and 15 degrees angle (https://www.printables.com/model/1552855-tobii-tracker-v5-fixed-mount-for-samsung-odyssey-g, here's a version with adjustable angles.

Same principle, I wanted an easy to print mount which would attach to the monitor without glue, screws or tape, and  which allowed me to fully operate the controls of the monitor.

Each mount kit consist of 4 parts, two arms and two clips. I've made two different versions of the arms (single side and dual side insertion), and three different sizes (5,6 & 7) of the 'cogwheel' which holds the clip to the arm. I made the different sizes to primarily accomodate for different printer accuracies. Size 6 was the best fit for my Bambu Lab P1S with 0.4 nozzle and eSUN PLA+. 

The single side solution is easier to use if you often have to adjust the angle of the tracker. You simply slide the entire tracker with the two clips to the side, adjust the angle, and then slide it back in. The downside could be that it might easily fall out (sideways) if you hit it.

The dual side solution keeps the trackes securely in place, but might be a bit trickier to use when you have to adjust the angle of the tracker. If you use a size 5 clip you could probably force the new angle directly without removing the clips from the arm though.

Both versions have the cable management groove in the rear.
For simplicity I made different print beds with the required models for each kit.