Fan Adapters for Collisto Head Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fan Adapters to allow 40mm fans to be mounted to original Collisto head cover. These are add on parts that still…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 224
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Fan Adapters to allow 40mm fans to be mounted to original Collisto head cover. These are add on parts that still require Original Collisto head cover https://www.prusaprinters.org/prints/122489-collistos-ender-3v2-hot-end-cover but allow a mixing and matching of fans as needed. This design still allows for original CL touch Brackets, and I am assuming BL touch bracket. This still allows for the main benefit of the Collisto design and still allows the magnetic attachment of head cover.
Print Settings
Supports:
Yes
Resolution:
Doesn't matter, but it does have to be somewhat accurate
Infill:
Doesn't matter
Filament:
Any Any
Any
Notes:
You should be able to use any filament for these 3 parts as they do not come into contact with any excess heat or wear. very minimal support for only the obvious areas laid in by hand in cura, and also printed with a brim to ensure parts stay secured until done. Misc 2mm/3mm screws and brass thread inserts are required, so it is handy to have a misc selection of these available if you choose to go this route.
This will still require the complete printing of all components here https://www.prusaprinters.org/prints/122489-collistos-ender-3v2-hot-end-cover
Category: 3D Printer Parts