Hole Mount PD65W USB-C Charger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 30mm hole mount for a PD65W USB-C charger module with a tethered screw cap dust cover.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 316
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 30mm hole mount for a PD65W USB-C charger module. The circuit board is like one of these: https://www.amazon.com/dp/B0DGLMWV5J
The mount consists of a mount, cap, nut, flange, tab and anchor. Printing with a layer height of 0.2mm or smaller is recommended for best thread production. Print in native orientation and use support from build plate when printing the mount, none with the cap.
The cap has a recess sized to accomodate a 3.2mm (1/8") bead chain end as does the anchor model. These allow the cap to be tethered via use of a length of bead chain. Secure the ends with CA glue or similar.
The mounting flange is printed seperately for a better finish. Install the flange before mounting on the host panel. Use 3M VHB tape (or similar) to secure the circuit board on the mount.
The tab can be attached using an M3 cap head screw to help reinforce the board placement (see pictures).
Fusion 360 source and .STEP files are included in addition to .STL files