X-Carve Datum Locator that actually fits!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A datum locator made for the 1000mm X-Carve modular waste board
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 79
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
I have tried many different downloads of datum locators that claim they are made for the X-Carve, yet they weren't made for the modular table. This design has counterbored M5 holes that are on 80mm center, just like the modular waste board that came on the last version of the 1000X1000 machines.
It sits 15mm high with 20mm wide legs. I relieved the inner corner to allow for a good fit with a sharp corner. I wanted to use as many of the screws as possible so that I can use the low-profile clamps and clamp a piece in for total topside work
I suggest using a 3D printer that will print as accurately as possible so that the piece is as close to 90 degrees as you can get.
Bolt in place with seven M5X25 SHCS for best use. Snug the corner bolt and run and indicator across the face before tightening all the bolts down in place.