Crankshaft Febi Bilstein seal installation tool for PSA 1.4/1.6 HDI engine
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This tool allows smooth installation of the seal without shock.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 115
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
It was printed on a I3 MK3 with Prusament PLA 0.3mm draft. Perimeters vertical and horizontal shells : 4. Infill : Honeycomb 15%. Auto generated support.
To make this tool operational, you will need a M8 bolt long enough, a pile of washer and some strong glue.
A M8 80mm and washers from 40mm diameter to a smaller M8 one were used. All washers were glued together to make a pile in order to have the largest area of pressure on the bell. The bolt head is also glued in its recess in the printed bracket.
When assembling the bell on the bracket, a rubbing fit shall be observed that allows guidance of the shell on the bracket.
To use it, position the seal sitting on its own bracket on the crankshaft flange. Then screw the printed bracket using the 6 screws of the flywheel. In order to to allow easy screwing, dig slightly the seal bracket where the screws enter in contact with it.
Warning : There are a few mm of thread engagement so do not tie the screw with a wrench. Instead use a socket alone.
Then position the bell on the protruding screw, put in place the washers and the nut. Using a ratchet box wrench, progressively push the seal in position.