Frosthaven Overlay: Pine Tree
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Here's a Pine Tree! This will fill either 3 hexes or a 10 foot square, depending on the game that you're playing.
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 145
- Wydruki
- 0
- Wyświetlenia
- 399
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props & Terrains
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made this Pine Tree to be used in place of the Frosthaven 3-hex overlay, but it'll work in any sort of TTRPG as well! To give it some more utility, I made the canopy and the trunk as separate parts. When aligned properly, the canopy can slide down over the trunk for a healthy tree, or if you're looking for a "deadlands" vibe, just use the trunk by itself! Lining it up is a bit tricky, but once you know how to do it, it's not too bad.
If you look at the base of the trunk piece, it's basically got three sections, one with one rock, one with two rocks, and one with three rocks. If you look at the underside of the canopy, you'll see that it's an irregular pentagon (as seen in the second screenshot). To line them up, you want the point of the pentagon made by its two longest sides (facing up in the screenshot) to point towards the one-rock section of the base.
No supports are required for this model, as the canopy has a nice flat bottom and is designed to be printed directly on the bed. In fact, if all that you want is the full tree, you can skip the trunk piece entirely and just put the canopy straight on the board!
As always, the .blend file and pre-supported .3mf (including the one that I used to print this on my Prusa MK4s, although the support points should work for SLA printers) for this model are available to my patrons at https://patreon.com/VirtuallyJason. If you appreciate my work and have a few dollars to spare each month, please consider joining!