Rc Glider Plane Motorglider 1.7m wingspan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
1.7m Motorglider printed in LW-PLA
- Ocena
- 0 / 5
- Polubienia
- 44
- Pobrania
- 301
- Wydruki
- 0
- Wyświetlenia
- 1574
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
Wings printed in LW-PLA in Vase Mode
Fuselage printed in PLA+
~380g flying weight
Power System
Pulsar Micro 1510 1650KV
12A ESC
4.7 × 2.4" folding propeller with 26 mm spinner
450 mAh 3S LiPo battery
Control System
5 g metal-gear servos
0.6 mm steel wire for control surfaces
any 3 channel receiver thats decently small
Structure
6 mm carbon spar for wings and fuselage
3 mm carbon tube for the outer wing sections
1.75 mm carbon rod for the V-tail
Wing and tail parts must be mirrored in the slicer to create the right-hand components.
Carbon rod and tube lengths can be taken directly from the STEP file of the complete aircraft.
drill a 2mm hole roughly at 15 degree 5-8cm from the tail into the carbon rod for the control linkages to pass through (pictures attached)
Hinges for the rudders are made with tape
