Core One + Spoolholder Split into Two Pieces to Hold Dry Box Cover

This is a remix of the Core One + spoolholder split into two pieces, one containing both a male and female bayonet fitting and the cap with a male fitting. This uses two O rings of the same type as the standard spoolholder. One piece can stay on the printer to support a spool and the cap can be removed and replaced to hold on a dry box cover. One piece is split into two for easy printing with no supports needed. There are holes to fit 3X8 mm stainless steel dowel pins to locate the two pieces, which then are glued with JB Weld Plastic Epoxy. The stl file has all three pieces that can be printed in PETG. To avoid strings, I suggest that each piece is printed separately. Split to objects in the slicer and print each separately by hiding the other two. The pieces are too tall to print separately in one print operation, so you will have to print, remove from the bed and print the next. The print settings from the original can be used.

There are two versions of the stl file, the original and a longer version. The original caused too much stress on the plexiglass cover with the thick gasket material I used. The second version is two mm longer so the force on the plexiglass cover is lower, but still sufficient to hold it on the side.

This is designed to be used with

and