Manta M8P v1/v2 cooling bracket 3510 fans
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
The model supports 3x 3510 (35x35mm) fans for cooling the motor drivers (less noisy than 4010 fans) and 1x 4010 (40x40mm) fan for cooling the CB1/CM4 module, as in the original design.
Using slightly smaller fans (3510) allows us to reduce system noise and keep the driver fans always on at full speed during printing and only regulate the fan dedicated to the CB1/CM4 module (via the internal temperature sensor), thus eliminating the need for an additional thermistor to control the driver temperature.
HW:
- 3x 3510 fans;
- 1x 4010 fan;
- 16x M3x12 SCHS screws;
- 4x M3x40/50 SCHS screws (depending on the thickness of the fans used);
- 16x M3 heatsets (4 for each fan).
Print settings:
- First Layer Height: 0.25mm;
- Layer Height: 0.2mm;
- Extrusion Width: 0.4mm, forced;
- Infill Percentage: 40%;
- Infill Type: Adative Cubic, Grid, Gyroid, Honeycomb, Triangle, Cubic;
- Wall Count: 3;
- Solid Top/Bottom Layers: 3;
- Seam Placement: Rear;
- Supports: None.