V2 -- Nema 17 Peristaltic Pump / Water Pump / measuring Pump
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
V2 Peristaltic Pump. Allows you to pump specific fluids without ever touching anything besides the tube itself.
- Ocena
- 3,833 / 5
- Polubienia
- 1488
- Pobrania
- 1903
- Wydruki
- 6
- Wyświetlenia
- 28 803
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
🌀 Peristaltic Pump (NEMA 17)
This is a compact, fully 3D-printable peristaltic pump designed to be driven by a NEMA 17 stepper motor.
The pump uses standard 608 bearings and soft tubing, making it easy to build with commonly available parts.
Peristaltic pumps are ideal for liquid handling because the fluid only contacts the tubing. This makes the design suitable for water, coolants, and other non-aggressive liquids.
⚙ How it works
The stepper motor rotates the bearing rotor.
As the bearings roll over the tubing, they compress it sequentially, pushing the liquid forward.
This design is self-priming and naturally prevents backflow without additional valves.
The flow rate can be precisely controlled by adjusting the stepper motor speed.
📦 Bill of Materials
Hardware
5× 608 bearings
1× NEMA 17 stepper motor
4× M3 screws (16 mm) – motor mounting
4× M3 screws (15–30 mm) – housing assembly
Tubing
8 mm soft tubing (silicone recommended)
Slightly smaller or larger tubing also works if the spacer is adjusted accordingly.
Electronics
Stepper motor driver (A4988, DRV8825, etc.)
Microcontroller (Arduino or similar)
Suitable power supply
🖨 Print Settings
Bearing holder / rotor
Infill: 60%
Layer height: 0.2 mm
Material: PLA / PETG / ABS
Housing
Infill: 15%
Layer height: 0.2 mm
Supports are not required when printed in the recommended orientation.
🛠 Assembly Notes
Press the 608 bearings firmly into the rotor (no glue required)
Insert the tubing into the housing before final assembly
Lightly gluing the tubing is recommended to prevent slipping during operation
Mount the pump assembly to the stepper motor using the 16 mm M3 screws
Test the pump at low speed before increasing RPM
⚠ Important Notes
Use soft tubing only – hard tubing will not work
Not designed for high-pressure applications
Chemical compatibility depends on the tubing material used
🔄 Updates
09.04.24 – Improved bearing press-fit based on community feedback
10.01.26 – Version 2 files uploaded
19.01.26 – Previously missing file added